backlash control option SCMCS-s-s-n-n

Novusun cnc controller
nvum/nvem/nvcm/nvmpg/nvec/SMC4-4-16A16B
Post Reply
lollette
Site Admin
Posts: 77
Joined: Wed Jun 06, 2018 8:34 am

backlash control option SCMCS-s-s-n-n

Post by lollette » Fri May 29, 2020 9:26 am

Hi I have a quick question I just got a SCMCS-s-s-n-n cnc controller doe sit have a backlash control option on it and if not is there a firmware I can get to give it backlash control option.
Black lash control is a setting in the control to take out any play on your lead screw so that you can retain accuracy when the machine moves . If you do not have it the machine will not be as accurate and your milling machine will not be able to make round holes or go to a specific spot on your part each and every time you tell it to . It will vary what ever the play you have is . It’s how you tune your machine .

lollette
Site Admin
Posts: 77
Joined: Wed Jun 06, 2018 8:34 am

Re: backlash control option SCMCS-s-s-n-n

Post by lollette » Fri May 29, 2020 9:27 am

Hello, this function is not supported, it can not be used on T-shaped screw with hysteresis

Post Reply